• We have updated to the newest version of the forum. Please let us know if you see any issues. And, yes, we know the shoutbox is gone. We'll see about getting it back if they make a newer version.

Slow and Low Mazda 3 build (Beware dialup users.....do people still use dialup???)

YSOSLO

YSOSLO

is the word, beotch
wow....that thing is low like Tom's tires are flush. I can't quite tell where you're going with the tails. Are you just smoothing out the little ridge detail around the outside of the area that surrounds the reverse lights?
 
minitrucker@heart

minitrucker@heart

Member
I not going to install the outer lenses. So I am filling in the gap that is left behind between the housing and the body panels. You can still see the gnarly gap on the qtr. mounted lights, on the hatch the gap has been eliminated. It is hard to see in the pictures w/o paint on them.
 
minitrucker@heart

minitrucker@heart

Member
It has given me some ideas on where to cut off for somewhat of a 2 tone...experimenting tomorrow. All that black is temp. has to be blocked before paint.
 
YSOSLO

YSOSLO

is the word, beotch
Does this thing have air ride or something?! I'd be afraid of scraping going over a tube of chapstick in this thing! Looks like it's getting a lot closer to done though.
 
mndsm

mndsm

I'M OFFENDED!
ITS SOOOO DUMPED. It came out awesome. Can't wait to see it in person. You're for sure lower than me.
 
mndsm

mndsm

I'M OFFENDED!
YSOSLO said:
Does this thing have air ride or something?! I'd be afraid of scraping going over a tube of chapstick in this thing! Looks like it's getting a lot closer to done though.
Click to expand...
Did you not see the giant air bags in place of the rear springs?
 
YSOSLO

YSOSLO

is the word, beotch
mndsm said:
ITS SOOOO DUMPED. It came out awesome. Can't wait to see it in person. You're for sure lower than me.
Click to expand...
Yeah, but Tom that's cuz you wanted to be all flush and ish.

mndsm said:
Did you not see the giant air bags in place of the rear springs?
Click to expand...
Scrolled right on past it apparently...lol
 
Last edited:
minitrucker@heart

minitrucker@heart

Member
G2 all the way....

But after I was done, I am pretty sure that high temp engine enamel would have worked the same.....but, I also had them sandblasted first allowing for super clean finished product.








also video.......

http://www.youtube.com/watch?v=o0Wt0yQPm-c



can't get this to embed.....not sure why? I see HTML is off but, I'm sure someone on this forum with there computer pedigrees could help
 
Last edited:
You must log in or register to reply here.
Top